This section gives you the detail of the training sessions for one of the important area of engineering field i.e. Designing & Detailing. You can explore our article “Instrumentation Design Engineering” for getting more clarity on the same. Below displayed training module programme is primarily designed for engineering aspects of instrumentation involved in real time industrial scenarios & projects. These aspects are followed & practiced in all the EPC/EPCM companies for all their projects depending upon the scope of project is being executed. This training programme is for the professionals who may have some work experience and even for freshers with zero work experience. Both professionals & freshers, who want to pursue & continue in this area can enroll for this training. Also, professionals who wants to change their existing working profiles like commissioning, service & marketing to a design job profile, this training programme will definitely make it possible for you.
Below are the List of Modules with specific topics included under our complete training programme. Considering today’s new era of educational revolution going on in our country, we promote full & selective(partial) training schemes, so that the individual getting enrolled for the training shall get the flexibility and ease to attend the complete training programme and even module wise or topic wise as well. However, we recommend to go for complete training programme in order to get trained fully & completely with respect to design engineering.
Please refer the training enrollment procedure details at the end of this page. All the training sessions shall be online sessions with all the details, support & guidance required.
Module-1
- Piping & instrumentation drawing (P&ID)
- Bill of material (BOM)
Module-2
- Instrument Index/list /BOM
- Instrument datasheets/specifications
- Hook-up drawing & BOM
Module-3
- System architecture & specifications
- Control logics & philosophy/narratives
- Input/output (I/O) & alarm list
Module-4
- Junction box datasheet & GA drawing
- Junction box (JB) schedule
Module-5
- Panel GA drawing & BOM
- Panel List/schedule
- Wiring drawing
Module-6
- Cable Schedule
- Cable tray layout & BOM
Module-7
- 2D/3D drawings
- Instrument location plan/layout
- Control Room Layouts
Module-8
- Electrical load consumption list
- Instrument Air consumption list
- Instrument Air header schedule
Module-9
- Factory acceptance test (FAT) procedure/report
- Site acceptance test (SAT) procedure/report
Module-10
- Design basis study/report
- Hazardous area classification & certification
- SIL report & study
- Cause & Effect drawing
Enrollment Procedure for Training Sessions:
- Choose your Modules or Topics from the above list; you can select one or even multiple modules or topics, as per your requirement.However, for getting trained fully in this field, we strongly recommend you to enroll for compete training programme, as partial knowledge will be as good as same to less knowledge.
- Mail your selected module(s) or topic(s) on [email protected], along with your queries or doubts if any.
- In return reply, you shall get the plan/schedule of training sessions, fees details and clarifications on the queries or doubts which you may have asked, that will help you to decide and proceed ahead for the chosen training module(s) or topic(s) enrollment.
- After completing & confirming on above steps, online training sessions shall be commenced as per given plan/schedule.